Integrated IR Bullet Camera
4.1.1
Adjusting Pan, Tilt, Rotate
1.
2.
3.
NOTICE!
Do not pan or rotate beyond 360˚ as shown in the figure below.
Do not tilt beyond 90˚ as shown.
Do not apply excessive force when adjusting the camera
positioning.
4.1.2
Adjusting Focus
1.
2.
3.
Bosch Security Systems, Inc.
Locate the 3 set screws on the bracket, as identified (6, 7,
8) in the figure above.
Loosen the 3 set screws using the supplied hex key.
Adjust the pan, tilt, and rotate as necessary.
Figure 4.2 Camera Pan, Tilt, and Rotate
Remove the cap covering the bottom of the camera.
Adjust the focus knob as necessary (see Figure 4.1 above).
Replace the cap over the bottom of the camera.
Installation Manual
Configuration | en
| 2.0 | 2011.06
17