Punch Selectors Removal And Replacement - Rexel CB345E Service And Parts Manual

SECTION 12 – PUNCH SELECTORS
MODELS CB405E, WB705E
Removal :-
1. Carry out previous sections where applicable.
2. Lift front end of selector so that lug on selector is clear of slot in push plate assembly and push
selector back to slide retaining spring off the back of the push plate assembly.
3. Disengage spring from selector.
Replacement :-
1. Engage spring onto rounded end of selector.
2. Push selector and spring together onto back of push plate assembly until rounded end of selector
engages into rectangular slot in push plate.
3. Check that selector snaps shut against push plate assembly and that selector lug locates freely in
slot in punch plate assembly.
ILLUSTRATED PARTS MANUAL:
FLOWLINE COMB & WIRE
BINDER RANGE
Page 33 of 55