Lower Casing Removal And Replacement - Rexel CB345E Service And Parts Manual

SECTION 7 – LOWER CASING
ALL MODELS
Removal :-
1. Carry out previous sections where applicable.
2. On CB405e and WB705e first in screw washer at rear of machine which fastens foot pedal jack
socket to casing.
3. Remove clipping tray.
4. Lift mechanism from lower casing.
5. Remove two rubber feet from front locations in lower casing.
Replacement :-
1. (CB345e and CB355e) Lift mechanism into lower casing and locate side frames into recesses and
retention clips.
2. (CB405e and WB705e) Lift mechanism into lower casing and position so that it doesn't sit fully
back in casing. Locate foot pedal jack socket into aperture in casing and fasten in place using jack
socket washer. Move mechanism into correct position in casing and locate side frames into recesses
and retention clips.
3. Push fit two front rubber feet through apertures in lower casing and into slots in side frames.
ILLUSTRATED PARTS MANUAL:
FLOWLINE COMB & WIRE
BINDER RANGE
Page 28 of 55