Table of Contents
Advertisement
Figure 25: Installing a Drive in the 5.25-Inch Drive Bay
Connect the power and data cables to the back of the drive. (See drive
10.
documentation for proper drive jumper settings and cable orientation.)
Close the case, as described in "Closing the system" on page 8.
11.
Reconnect the power cord and turn on the system.
12.
Run the configuration software that came with the drive, if required.
13.
14.
The system should automatically recognize the new drive. If it does
not, you may need to set jumpers on the drive or change settings in the
BIOS Setup utility.
Installing Components
43
Advertisement
Table of Contents
Troubleshooting
