Gateway ALR 7300 Maintaining And Troubleshooting page 110

100 Maintaining and Troubleshooting the Gateway ALR 7300 Server
Error Message
Keyboard not detected.
Keyboard stuck key failure.
Memory errors were
detected while the system
powered up.
Memory size error.
Non-system disk or disk
error.
Not enough memory.
Print queue is full.
Printer is out of paper.
Required parameter
missing.
Syntax error.
Time and date not set.
Write protect error.
Solutions
See "The keyboard doesn't work." on
page 94.
Turn off the system and check the keyboard
cable.
Remove any objects that may be resting on
the keyboard, and then restart the system.
Check for sticky keys. Clean the keyboard if
necessary.
See "Memory errors were detected during
system start up." on page 89.
Enter BIOS Setup and save the memory
configuration.
Eject the diskette and press Enter.
If the diskette is bootable, check it for errors.
Close all programs that are not currently in
use.
Wait until the current print job has completed
before sending another print job.
If you receive this error often, you need to add
memory to the printer.
Add paper to the printer.
Make certain the printer is online.
Make certain you entered the right command.
If you are trying to exit MS-DOS to return to
Windows, type exit and press Enter.
Make certain you entered the right command.
If you are trying to exit MS-DOS to return to
Windows, type exit and press Enter.
Enter BIOS Setup to set the system date and
time.
Move the write-protection tab over the hole on
the back of the diskette.