Gateway ALR 7300 Maintaining And Troubleshooting page 60

50 Maintaining and Troubleshooting the Gateway ALR 7300 Server
Figure 32: Installing a Hard Drive in the Rear Drive Bay
Place the hard disk assembly into the chassis and secure it to the
8.
chassis using the screws you removed in Step 5 (see Figure 32).
Connect the data and power cables to the hard drive, making sure the
9.
cables match their original position. (See the drive documentation for
proper drive jumper settings and cable orientation.)
Close the case, as described in "Closing the system" on page 8.
10.
11. Reconnect the power cord and turn on the system.
12. The system should automatically recognize the new drive. If it does
not, you may need to set jumpers on the drive or change settings in the
BIOS Setup utility.