Watch Dog Enable/Disable - Supermicro X10SLD-F User Manual

Watch Dog Enable/Disable

Watch Dog (JWD1) is a system monitor that
can reboot the system when a software ap-
plication hangs. Close Pins 1-2 to generate a
non-maskable interrupt signal for the application
that hangs. Close Pins 2-3 to reset the system if
an application hangs. See the table on the right
for jumper settings. Watch Dog must also be en-
abled in the BIOS.
UID
SW1
PWR LE5
IPMI_LAN
BMC
X10SLD-F/HF
Rev. 1.00
JPME2
BIOS
Intel
VBAT
PCH
JBT1
JPME1
A
JKVM1
USB0
(3.0)
CPU1
2-25
Chapter 2: Installation
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 NMI (default)
Pins 2-3 Reset
Open Disabled
A. Watch Dog Enable