Watch Dog Enable/Disable; Bmc Jumper - Supermicro Supero H8SME-F User Manual

Watch Dog Enable/Disable

JWD1 enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will generate
a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.

BMC Jumper

JPB1 is used to enable or disable
the BMC (Baseboard Management
Control) Chip and the onboard IPMI
connection.This jumper is used
together with the IPMI settings in the
BIOS. The default position is on pins
1 and 2 to Enable BMC. See the table
on the right for jumper settings.
Jumper Settings (JWD1)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user must write
their own application software to disable the Watch
Dog Timer.
BMC Jumper Enable (JPB1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
2-17
Chapter 2: Installation
Watch Dog
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled (default)
Disabled