Removing Memory Modules; Memory Support; Memory Population Guidelines - Supermicro X10SLD-F User Manual

Removing Memory Modules

Reverse the steps above to remove the DIMM modules from the motherboard.

Memory Support

Channel A, Slot 1
Channel A, Slot 2
(Blue Slot)
Channel B, Slot 1
Channel B, Slot 2
(Blue Slot)
The X10SLD-F/-HF supports up to 32GB of Unbuffered (UDIMM) DDR3 ECC
1600/1333/1066 MHz in 4 memory slots. Populating these DIMM modules with a
pair of memory modules of the same type and same size will result in interleaved
memory, which will improve memory performance. Please refer to the table below:

Memory Population Guidelines

Please follow the table below when populating the X10SLD-F/-HF.
DIMM Slots per DIMMs Populat-
Channel ed per Channel
2
2
Notes
•
Be sure to use memory modules of the same type, speed, and frequency
on the same motherboard. Mixing of memory modules of different types
and speeds may damage the motherbaord.
•
Due to memory allocation to system devices, the amount of memory that
remains available for operational use will be reduced when 4 GB of RAM
is used. The reduction in memory availability is disproportional. See the
following table for details.
Towards the CPU
Towards the edge of the motherboard
DDR3 Unbuffered ECC (UDIMM) Memory
DIMM Type
1 Unbuffered
DDR3
2 Unbuffered
DDR3
POR Speeds
1066, 1333, 1600
1066, 1333, 1600
2-11
Chapter 2: Installation
Ranks per DIMM (any
combination)
Single Rank, Dual Rank
Single Rank, Dual Rank