Replacing A Processor - Gateway 9210 User Manual

Replacing a processor

This server is compatible with Intel
automatically detects the processors each time you turn on the server. Whenever you install
a new processor, you should first install the most current version of the BIOS. For
instructions, see
Warning
Caution
To replace a processor:
1
Install the most current BIOS version. For instructions, see
page 59.
2
Follow the instructions in
3
Follow the instructions in
4
Unplug the heat sink's cooling fan from the system board.
5
Press down on the heat sink locking lever on each side, push them slightly away from
the heat sink, then lift the levers out of the way.
®
"Updating the BIOS" on page
Processors and heat sinks may be hot if the computer has
been running. Before replacing a processor or heat sink,
allow them to cool for several minutes.
A heat sink must be installed on the processor. Installing
a processor without a heat sink could damage the
processor.
"Preventing static electricity discharge" on page
"Opening the server case" on page
www.gateway.com
®
Pentium 4 or Celeron
59.
®
processors. The server
"Updating the BIOS" on
30.
29.
45