Error Messages - Gateway 9210 User Manual

Error messages

These messages often indicate procedural errors such as typing an incorrect keystroke or
trying to save a file to a write-protected diskette. Some messages, however, may indicate
a problem that requires further troubleshooting.
Diskette drive 0 seek to track 0 failed
■
Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the drive settings are correct.
Error loading operating system
■ The master boot record may be corrupt. For troubleshooting information, see
master boot record is corrupted" on page
Hard disk controller failure
■
Make sure that the hard drive cable is connected securely.
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the correct drive type is selected.
Hard disk controller failure - press F1 to try reboot
■
The drive controller may be defective. Press F1 to try to restart the server. For more
information about running diagnostics on your hard drive, see your operating system's
documentation.
Insert bootable media device
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the drive settings are correct.
■
See "Your server does not recognize an SCSI drive (applies to SCSI configured servers
only)" on page 73
Invalid configuration information
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the settings are correct.
■
Reset the BIOS. For instructions, see
Invalid partition table
■ The master boot record may be corrupt. For troubleshooting information, see
master boot record is corrupted" on page
for a possible solution.
"Changing jumper settings" on page
www.gateway.com
74.
74.
"The
60.
"The
67