Table of Contents
Advertisement
Figure 9: PT-110EDID XGA Line Transmitter
#
1
XGA IN 15-pin HD (F)
Connector
2
12V DC
3
EDID CAPTURE Button Press to acquire the EDID information from the display (see
4
5
LINE OUT RJ-45
Connector
6
VS Switch
7
HS Switch
8
ON LED
7.2
Connecting the PT-110EDID XGA/Line Transmitter
You can use the PT-110EDID XGA Line Transmitter together with the TP-120 XGA
Line Receiver to configure an XGA-to-Twisted Pair transmitter and receiver system.
i
To connect the PT-110EDID with the TP-120, as the example in
illustrates, do the following:
1. On the PT-110EDID, connect the XGA source (for example, the 15-pin HD
output from a computer's graphics card) to the XGA INPUT 15-pin HD (F)
connector.
2. On the TP-120, connect the XGA OUT 15-pin HD (F) connector to the XGA
acceptor (for example, a monitor).
22
Feature
Connect to the UXGA source
+12V DC connector for powering the unit
Section
STATUS LED
Illuminates during normal operation; flashes when acquiring
the EDID
Connects to the LINE IN RJ-45 connector on the TP-120
UXGA/Audio Line Receiver
Slide up to set the V SYNC to NEGATIVE polarity;
slide down to set the V SYNC to NORMAL polarity
By default, both switches are set down (for normal V SYNC and
H SYNC polarity)
Slide up to set the H SYNC to NEGATIVE polarity (NEG);
slide down to set the H SYNC to NORMAL polarity
By default, both switches are set down (for normal V SYNC and
H SYNC polarity)
Illuminates when receiving power
Before connecting the transmitter and receiver system you can
acquire the EDID from the display or set the system to the default
EDID, see
Section
9)
9.
TP-121/3/5EDID, PT-110EDID - Your PT-110EDID
Function
Figure 10
Advertisement
Table of Contents
