12.0)
ATTACHING BURNER BOX ASSEMBLY
1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.
2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed clips
onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two required) of the
reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner box assembly.
3.
The heater can be mounted horizontally or at an angle of up to 45 degrees maximum from horizontal.
When angle mounting, the burner box unit must be positioned upright as shown below. FAILURE TO INSTALL THE
BURNER BOX IN AN UPRIGHT POSITION WILL VOID THE MANUFACTURER'S WARRANTY.
–24–
Form #43343330
May 08