Adding Optional 90* Elbow (Lts Only); Adding Optional Corner Reflector (Lts Only); Attaching Control Box Assembly - Space-Ray LTS Series Assembly, Installation And Operation Instructions

INCORRECT
INSTALLATION
CORRECT
INSTALLATION
4. The tube at the coupling joints must be covered. Slide the reflectors together and provide a one-inch overlap. (This will
allow for the natural expansion and contraction of the heater when in operation.) Secure reflectors together by sliding
speed clips on the reflector joint edges. One speed clip is required for each side of the reflector. Tighten the reflector
clamps. !D0 NOT OVER-TIGHTEN! Make sure that the reflector can slide under the clamp during heater operation.
12) ADDING OPTIONAL 90° ELBOW (LTS ONLY)
1. The optional 90° elbow must be located a minimum
of 10 ft. after the control box.
2. Hang the body sections in a 90° ("L") shaped pattern.
Allow spacing for the elbow. The distance from one
end of the elbow to the centerline of the opposite leg
is 13" as shown.
3. Join the tube ends of the body sections and the
elbow together and secure with tube couplings as
described in Section 11.
(Optional)
13) ADDING OPTIONAL CORNER REFLECTOR
(LTS ONLY)
1.
2.
3.
Place the corner reflector over the reflectors of both
body sections.
Secure by sliding speed clips on the reflector edges.
One speed clip is required for each side of reflector.
The corner reflector can be used only when the long
axis of the heater Is level and mounted in a
horizontal position.
0
/Y^
Speed Clip ^ ^
CORNER REFLECTOR
(Optional)
s*
14)
ATTACHING CONTROL BOX ASSEMBLY
1. Attach the control box and gasket to end of tube flange and secure with 1/4-20 locknuts. NOTE: The control box must
be mounted to a 10 ft. aluminized steel body section regardless of configuration used.
2. A 3/8" connector is located on the left side of the control cabinet to provide strain relief for field wiring to the draft
inducer junction box (refer to Section 22 on Electrical Connections and Connection Wiring Diagram for wiring between the
control box and the draft Inducer.)
Form #43155010
Fob-04