Adding Body Reflectors; Attaching Burner Box Assembly - Space-Ray FUSION Series Installation & Operation Instructions

Infrared radiant poultry tube heater, single and two stage push through system positive pressure

Table of Contents

9.3)

ADDING BODY REFLECTORS

1. Slide the reflectors on the tube support/hanger brackets and through the wire hangers.

2. The tube at the coupling joints must be covered. Slide the reflectors together and provide an overlap of two

(2") inches for the first reflector overlap after the control unit. This will allow for the natural expansion and

contraction of the heater when in operation. Note: The heaters can expand and contract up to 1-3/4".

3. Secure the reflectors as shown in Detail "A" using #10 x 1/2" self-drilling sheet metal screws at each tube

support/hanger bracket.

10.0)

1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.

2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed

clips onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two

required) of the reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner

box assembly.

3. The heater can be mounted horizontally or at an angle of up to 45 degrees maximum from horizontal.

When angle mounting, the burner box unit must be positioned upright as shown below Failure to install the

control box in an UPRIGHT position will VOID the manufacturer's warranty.

-18-

Form 43343100

April 2022 A

Table of Contents