Assembly Of Extension Section - Space-Ray Infrared Radiant Tube Heater PTS Series Installation And Operation Instructions Manual

10.1

ASSEMBLY OF EXTENSION SECTION

See typical assembly overview (Section 8.0) for typical complete assembly. Assemble additional extension
sections as required for all systems. (See Sections 7.0, and 8.0 for typical layout details.)
Join the tube sections together and secure with tube couplings as described below:
WARNING:
1. Place the compression coupling over the end of the tube.
2. Use the small hole at the centerline of the coupling to check that the coupling is inserted correctly.
3. Partially tighten the bolt nearest the end of the tube (approximately half closed).
Form #43343330
May 08
THE FOLLOWING COUPLING TIGHTENING INSTRUCTIONS MUST
BE FOLLOWED PROPERLY TO AVOID FUTURE PROBLEMS.
–19–