GarrettCom Magnum 6K32T Hardware User Manual page 78

Magnum 6K32T & 6K32TRC Managed Switch
lead from 48V or –48V supply must be connected to the post labeled "+".
The connection procedure is straightforward. Simply connect the DC leads to
the Switch's power terminals, positive (+) and negative (-) screws. Ensure that each lead
is securely tightened.
The 24VDC and 125VDC terminal block on Magnum 6K32T & 6K32TRC's is
similar to that described in the –48VDC information above.
C5.1 UL Requirements
The following must be adhered to in order to conform to UL requirements:
1. Minimum 18 AWG cable for connection to a Centralized DC power source.
2. Minimum 14 AWG cable for connection to earthing wiring.
3. Use only with Listed 10 A circuit breaker provided in building installation.
4. "Complies with FDA radiation performance standards, 21 CFR subchapter J."
or equivalent.
5. Fastening torque of the lugs on the terminal block: 9 inch pound max.
6. Centralized DC Power Source cable securement, use at least four Minimum 14
AWG cable ties to secure the cable to the rack at least 4 inches apart with the
first one located within 6 inches of the terminal block.
C6.0 ORDERING INFORMATION
To order the optional Dual-Source -48VDC power supply factory installed,
order "Dual-Src48V" as a separate line item following the product model.
Example: Magnum 6K32T & 6K32TRC-48VDC
or Dual-Src48V-SWITCH with the ON-OFF manual switch.
Similarly, order the "Dual –source 24VDC" or "Dual-source 125VDC" as a
separate line item following the product model.
Example: Magnum 6K32T & 6K32TRC-24VDC or Magnum 6K32T &
6K32TRC-125VDC
C7.0 OPERATION
Operation of the Dual-Source Magnum 6Ks-48VDC, 24VDC and 125VDC
Switch models are identical to that of the standard models.
www GarrettCom com . .
Dual-Src-48V for the regular DS model with no ON-OFF switch
Dual-Src24V for regular models with no ON-OFF switch
Or Dual-Src125V-Switch for models with the ON-OFF switch
73
Installation and User Guide 05/07)