Iosiprouteman Messages; Iosiprouteman-3 - Cisco Catalyst 4500 Series Message Manual

Cisco ios system message guide
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

IOSIPROUTEMAN Messages

Error Message C4K_IOSINTF-5-TXPKTDROPONETHERCHANNEL:Dropping transmit packet out of
interface [char]
IOSIPROUTEMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IP Route Manager (IOSIPROUTEMAN)
messages.

IOSIPROUTEMAN-3

Error Message C4K_IOSIPROUTEMAN-3-ADJMANNOMOREADJS:AdjMan:
hardware adjacency resources exhausted, performance may be degraded.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBADJ:IOS IP Route Manager:No
memory available to allocate FIB Adjacency for [object-info]
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBENTRY:IOS IP Route Manager:No
memory available to allocate FIB Entry for [ip-addr]
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-48
A packet that should be transmitted out of a port channel was dropped during transitions
Explanation
in the port channel membership. This condition occurs when a packet is transmitted out of the
aggregate port by higher layer protocols, but the software cannot find the specific state information
or when physical ports transition into or out of the port channel membership.
If the problem persists, contact your technical support representative.
Recommended Action
Explanation
The hardware adjacency resources have been exhausted. The supervisor engine will
forward packets to this adjacency in the software. This action will likely represent a significant
performance degradation.
Recommended Action
Reduce the number of adjacencies that are loaded into the routing table, and
then clear the IP routing table.
Explanation
The switch does not have sufficient memory to allocate space for this adjacency; the
supervisor engine will forward it in the software instead.
Reconfigure the network so that there are fewer hosts that are directly adjacent
Recommended Action
to the Catalyst 4500 series switch, and then clear and reload all of the routes (or reboot) so that the
adjacent hosts that were being sent to the software get reloaded.
The switch has insufficient memory to allocate space for the route that is associated with
Explanation
this network.
Contact your technical support representative because memory leaks might
Recommended Action
exist.
Chapter 2
Messages and Recovery Procedures
OL-11541-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents