Entering Diagnostic Mode; Status Label; Figure 8 ^D960)1 Or ^K Test Pattern; Figure 9 ^D323-List Enablements Example - Microcom 226 User Manual

Printer Modes
4.4.1

Entering Diagnostic Mode

To enter the diagnostic mode, press and hold the print button in while turning on the printer.
Release the button after the status light indicator starts to blink and the printer will power up
into diagnostic mode.
4.1.2

Status Label

The printer will print the Status label after the printer performs a powered up and enters the
diagnostic mode. The status label prints out the reports that are generated by the ^D323),
^D326), ^D325), and ^D324) commands.
26
Figure 8 ^D960)1 or ^K Test Pattern
Enablements (D323 or <Ctrl> Y)
User Interface
Software flow control:
Hardware flow control:
Format
Operational
Auto power-up label:
Auto top-of-form alignment:
Auto media sizing:
Auto alignment after error:
Cutter:
PMH:
Figure 9 ^D323-List Enablements Example
(D770) enabled
(D771) disabled
(D720) disabled
(D722) disabled
(D723) disabled
(D724) disabled
(D740) disabled
(D741) disabled
226/426 User's Guide
Chapter 4