Microcom 226 User Manual page 54

Maintenance and Adjustments
Note: The printer takes approximately 5 minutes to read the read and copy the new
code. If a power loss occurs during this time the printer will revert back to the
previous code and the update process will have to be restarted.
6. The flash memory has been recovered and the firmware may be upgraded using the
procedure outlined in section 3.1.
Note: The emulation program used to transfer the MCA file via the serial port must be
capable of sending Binary data, (i.e., Tera Term Pro) for proper transfer to occur. If
the transfer was not successful the emulation program used, may not have the ability
CAUTION: Do not send any unnecessary characters or turn the printer
off during the flash memory update. Failure to observe this precaution
44
to transfer Binary data.
may result in the printer becoming inoperable.
Chapter 6
226/426 User's Guide