Microcom 226 User Manual page 34

Printer Modes
4.2.3.27 >FILE IS READ ONLY< (D9)
This enquiry response typically indicates that a save or delete command is being issued to
the printer and that the file is a protected file stored in the printer. If the printer is configured
for byte responses, the code ASCII 0xD9 will be issued from the printer in response to an
enquiry command.
4.2.3.28 >INADEQUATE FLASH SPACE< (DA)
This enquiry response indicates that the available flash memory is less than the total size of
a file being saved to flash memory. If the printer is configured for byte responses, the code
ASCII 0xDA will be issued from the printer in response to an enquiry command.
4.2.3.29 >I/O FAILURE< (DB)
This enquiry response indicates that the printer has a failure with either the I/O hardware or
with the I/O firmware. If the printer is configured for byte responses, the code ASCII 0xDB
will be issued from the printer in response to an enquiry command.
4.2.3.30 >FONT/GRAPHIC NOT FOUND< (DC)
This enquiry response typically indicates that a font being specified a script file does not
exist in flash memory. If the printer is configured for byte responses, the code ASCII 0xDC
will be issued from the printer in response to an enquiry command.
4.2.3.31 >SWITCH 0 ACTUATED< (E1)
This enquiry response typically indicates that switch 0 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE1 is
issued from the printer in response to an enquiry command.
4.2.3.32 >SWITCH 1 ACTUATED< (E2)
This enquiry response typically indicates that switch 1 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE2 is
issued from the printer in response to an enquiry command.
4.2.3.33 >SWITCH 2 ACTUATED< (E3)
This enquiry response typically indicates that switch 2 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE3 is
issued from the printer in response to an enquiry command.
4.2.3.34 >TOF SWITCH ACTUATED< (E4)
This enquiry response typically indicates that the Top-Of-Form (TOF) switch is actuated
while in text or verbose response sets. If the printer is configured for byte responses, the
code ASCII 0xE4 is issued from the printer in response to an enquiry command.
24
Chapter 4
226/426 User's Guide