Operation - Craftsman 315.114850 Operator's Manual

BATTERY PACK/CHARGER
If not purchased as a kit, the battery pack and charger are
not included with your light. They are both sold sepa-
rately. If you need to purchase the battery pack and
charger, use the following information:
MODEL NO. BATTERY PACK
315.114071 Item No.
(1323517 or 1323903) (1425301 )
BATTERY PACK
The battery pack for this light has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until light on front of charger changes
from red to green.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operating light followed
by recharging) for batteries to become fully charged.
CHARGING BATTERY PACK
See Figure 1.
■ Use only the recommended battery pack and charger
with the light.
■ Make sure power supply is normal household
voltage, 120 Volts, 60 Hz, AC only.
■ Connect charger to power supply.
■ Place battery pack in charger aligning raised rib on
battery pack with groove in charger. See Figure 1.
■ Press down on battery pack to be sure contacts on battery
pack engage properly with contacts in charger.
■ Normally, the red LED on charger will come on. This
indicates charger is in fast charging mode.
■ Red LED should remain on for approximately 1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is
in trickle charge mode. Note: Green LED will remain
on until battery pack is removed from charger or
charger is disconnected from power supply.
■ If both yellow and green LED come on, this indicates a
deeply discharged or defective battery pack.

OPERATION

CHARGER
11375 Item No.
9
Allow battery pack to remain in charger for 15 to 30
minutes. When battery pack reaches normal voltage
range, red LED should come on.
If red LED does not come on after 30 minutes, this
indicates a defective battery pack and should be
replaced.
■ After normal usage, a minimum of 1 hour of charging
11041
9
time is required to fully recharge battery pack.
■ The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
■ Do not place charger and battery pack in an area of
extreme heat or cold. It will work best at normal room
temperature.
Note: Charger and battery pack should be placed in a
location where the temperature is more than 50°F but
less than 100°F.
■ When batteries become fully charged, unplug charger
from power supply and remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERY PACK
When using the light continuously, the batteries in the
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
battery pack in charger. If green LED continues to remain
on, return battery pack to your nearest Sears Repair
Center for checking or replacing.
Note: This situation only occurs when continuous use of
your light causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "CHARGING
BATTERY PACK" for normal recharging of batteries. If
the charger does not charge the battery pack under
normal circumstances, return both the battery pack and
charger to the nearest Sears Repair Center for electrical
check.
BATTERY PACK
SHOWN IN CHARGER
CHARGER
RED LED ON INDICATES
FAST CHARGING MODE
GREEN LED ON AFTER FAST CHARGING
CYCLE, INDICATES FULLY CHARGED BATTERY
PACK AND IN TRICKLE CHARGE MODE.
YELLOW AND GREEN LEDS ON INDICATES DEEPLY
DISCHARGED OR DEFECTIVE BATTERY PACK.
7
Fig. 1