Maintenance - Craftsman 315.114850 Operator's Manual

WARNING:
When servicing, use only identical
Craftsman replacement parts. Use of any other part
may create a hazard or cause product damage.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. They contain
chemicals that can damage, weaken or destroy
plastic.
FLUORESCENT TUBE REPLACEMENT
See Figure 4.
When purchasing replacement fluorescent tube, request
recommended part number 7819602. See Figure 5.
TO REPLACE FLUORESCENT TUBE:
■ Remove battery pack from worklight. See Page 8.
■ Remove screw to release lens cover. Remove lens
cover by pulling forward and lifting from the housing.
■ To remove old fluorescent tube from spring, gently
grasp the lower edge of the rubber cushion and sides
of bulb. Carefully work tube in a side-to-side motion
while easing tube forward and up until tube is free from
the spring. Do not pull fluorescent tube straight out
from its center, as this increases chance of breakage.
PULL LENS COVER
FORWARD TO REMOVE
SCREW
LENS COVER
FLUORESCENT TUBE

MAINTENANCE

Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
■ Insert new fluorescent tube in spring by aligning prongs
■ Replace lens cover by sliding lower edge into housing.
■ Replace battery pack.
RUBBER
CUSHION
9
WARNING:
Do not attempt to modify this worklight
or create accessories not recommended for use with
this worklight. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
Remove rubber cushion from old fluorescent tube and
place on top of new tube, rounded edge facing
outward.
on tube with holes in tube socket area. Gently push
down on base of new tube until fully engaged. Do not
force tube into place.
Align screw holes at top. With a hand tool, tighten
screw. Do not use drill included in kit to tighten screw,
as drill torque may damage lens cover.
BULB
SOCKET AREA Fig. 5