Download Print this page

Rules For Safe Operation - Craftsman 315.222560 Owner's Manual

10 mm (3/8 in.), 16.8 volt cordless drill-driver variable speed / reversible
Hide thumbs

Advertisement

RULES FOR SAFE OPERATION
(Continued)
M
M
An extension cord should not be used unless
absolutelynecessary, Use of improper
e_tension cord could result in a dsk offiro and
electdc shock. If extension cord must be used,
make sure:
a,
That pinson plug of extension cord are the
same number, size and shape as those of
plug on charger.
b, That extension cord is properlywired and in
good electrical condition;and
c.
That wire size is large enoughfor AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25'
50' 100'
Cord Size (AWG)
16
16
16
Note: AWG = Amedcan Wire Gage
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG, If damaged,
have replaced immediately by a qualified
serviceman.
M
M
M
Do not operate charger if it has received a
sharp blow, been dmppad, or otherwise
damaged In any way; take it to a qualified
serviceman,
Do not disassemble charger;, take it to e
qualified serviceman when service or repair is
required. Incorrectreassembly may result in a
risk of electdc shock or fire.
To reduce dsk of electdc shock, unplug charger
from outlet before attempting any maintenance
or cleaning, Turning off controls will not reduce
this dsk.
Do not use charger outdoors,
Disconnectcharger from power supplywhen
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequentlyand use them to instructothers who
may use this tool. If you loan someonethis tool,
loanthem these instructionsalso.
Look for this symbol to point out important safety precautions.
It means attantionf!! Your
safety is involved.
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BATTERIES
When usingyour drill-drive! continuously, the batteries in your battery pack will become hat. You should leta hot
battery pack cool down for approximately 30 minutes before attemptingto recharge. When the battery peck
becomes discharged and is hot, this will cause the yellow and green lightson your battery charger to come on
instead of the red light. The yellow and green lights indicate soft start mode and will switchto green only, indicat-
ing slow charge mode. The red light indicatesfast charge mode, 1 hour charge time. The green light indicates
slow charge mode, requiring overnight chargingfor batteries to roachfull charge. If the green lightcomes on
after letting battery pack cool down, remove it from charger for additionalcooling.0 nce the battery pack cools
down, you can recharge battery pack in fast charge mode as normal. Do not leave a hot battery peck in charger
until it coolsdown, The green lightwill not go off when battery pack cools, If fast charga mode is desired, you
must physicallyremove a hot battery pack from the charger, let it cool, then place it back in charger after it has
cooled down.
Note: This situationonly occurswhen continuous use of your drillcauses the batteriesto become hot, It does
not occur under normal cimumstances. Refer to "CHARGING BA'I-rERY PACK" for normal rechargingof
batteries. If the charger does not charge your battery pack under normal circumstances,return both the battery
pack and charger to your nearest Sears repair center for electrical check.

Advertisement

loading

  Related Manuals for Craftsman 315.222560