Craftsman 315.114850 Operator's Manual page 32

1/2 in., 19.2 volt cordless drill-driver variable speed / reversible
Hide thumbs Also See for Craftsman 315.114850:
Table of Contents

Advertisement

REMOVING BLADE
See Figure 5.
n Remove battery pack from saw.
n Remove blade wrench from storage area.
n Position saw as shown in figure 5, depress spindle lock
button, and remove blade screw.
NOTE: Turn blade screw clockwise to remove.
n Remove outer blade washer.
NOTE: Blade can be removed at this point.
WARNING:
Current attachments and accessories
available for use with this tool are listed above.
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
EDGE GUIDE
Use the edge guide provided with your saw when mak-
ing wide rip cuts. A five inch scale has been provided on
the edge guide. When using the width of cut scale on the
base in combination with the edge guide, cuts can be
made up to 6 in. to the left of the edge guide or 8-7/8 in.
to the right of the edge guide.
The edge guide helps prevent the blade from twisting in a
cut. The blade twisting in a cut can cause kickback.
INSTALLING EDGE GUIDE
See Figure 6.
n Remove battery pack from saw.
n Place edge guide through holes in saw base.
n Adjust edge guide to the width needed.
n Tighten edge guide screw (wing screw) securely.
NOTE: When using a edge guide, position the face of the
edge guide firmly against the edge of workpiece. This
makes for a true cut without pinching the blade. The guid-
ing edge of workpiece must be straight for your cut to be
straight. Use caution to prevent the blade from binding in
the cut.
ASSEMBLY
SPINDLE LOCK
SPINDLE LOCK
SCREW
EDGE
GUIDE SCREW
(WING SCREW)
PLACE EDGE
GUIDE THRU HOLES
12
TO LOOSEN
LOWER BLADE
GUARD LEVER
TO TIGHTEN
Fig. 5
EDGE GUIDE
Fig. 6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents