Table of Contents
Advertisement
Recall the Default Oscilloscope Setup
To recall the default oscilloscope setup:
1 Press [Default Setup].
The default setup restores the oscilloscope's default settings. This places
the oscilloscope in a known operating condition. The major default settings
are:
Table 2
Horizontal
Vertical (Analog)
Trigger
Display
Other
Labels
In the Save/Recall Menu, there are also options for restoring the complete
factory settings (see
a secure erase (see
Use Auto Scale
Use [Auto Scale] to automatically configure the oscilloscope to best display
the input signals.
1 Press [Auto Scale].
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
Default Configuration Settings
Normal mode, 100 µs/div scale, 0 s delay, center time reference.
Channel 1 on, 5 V/div scale, DC coupling, 0 V position, 1 M
Edge trigger, Auto trigger mode, 0 V level, channel 1 source, DC coupling,
rising edge slope, 40 ns holdoff time.
Persistence off, 20% grid intensity, 50% waveform intensity.
Acquire mode normal, [Run/Stop] to Run, cursors and measurements off.
All custom labels that you have created in the Label Library are preserved (not
erased), but all channel labels will be set to their original names.
"Recalling Default Setups"
"Performing a Secure Erase"
You should see a waveform on the oscilloscope's display similar to this:
Getting Started
impedance.
on page 322) or performing
on page 322).
1
35
Advertisement
Table of Contents
