Table of Contents
Advertisement
If the setup does not produce a stable trigger, the I2S signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
To display I2S serial decode, see
N O T E
I2S Serial Decode
To set up the oscilloscope to capture I2S signals, see
Signals"
For I2S triggering setup see
N O T E
To set up I2S serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 Press the Base softkey to select the number base in which to display
3 If the decode line does not appear on the display, press the [Serial] key
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
If the setup does not produce a stable trigger, the I2S signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
on page 435.
decoded data.
to turn it on.
decode data.
"I2S Serial Decode"
"I2S Triggering"
on page 438.
I2S Triggering and Serial Decode
on page 441.
"Setup for I2S
26
441
Advertisement
Table of Contents
