Agilent Technologies InfiniiVision 4000 X Series User Manual page 135

6
Digital Channels
Bus values can be shown in hex or binary.
Using cursors to To read the digital bus value at any point using the cursors:
read bus values
1 Turn on Cursors (by pressing the [Cursors] key on the front panel)
2 Press the cursor Mode softkey and change the mode to Hex or Binary.
3 Press the Source softkey and select Bus1 or Bus2.
4 Use the Entry knob and the X1 and X2 softkeys to position the cursors
where you want to read the bus values.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide 135