Input A Waveform; Recall The Default Oscilloscope Setup - Agilent Technologies 2000 X-Series User Manual

Do not negate the protective action of the ground connection to the oscilloscope. The
WA R N I N G
oscilloscope must remain grounded through its power cord. Defeating the ground
creates an electric shock hazard.

Input a Waveform

The first signal to input to the oscilloscope is the Demo 2, Probe Comp
signal. This signal is used for compensating probes.
1 Connect an oscilloscope probe from channel 1 to the Demo 2 (Probe
2 Connect the probe's ground lead to the ground terminal (next to the

Recall the Default Oscilloscope Setup

To recall the default oscilloscope setup:
1 Press [Default Setup].
The default setup restores the oscilloscope's default settings. This places
the oscilloscope in a known operating condition. The major default settings
are:
Table 2
Horizontal
Vertical (Analog)
Trigger
Display
Other
Labels
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
Comp) terminal on the front panel.
Demo 2 terminal).
Default Configuration Settings
Normal mode, 100 µs/div scale, 0 s delay, center time reference.
Channel 1 on, 5 V/div scale, DC coupling, 0 V position.
Edge trigger, Auto trigger mode, 0 V level, channel 1 source, DC coupling,
rising edge slope, 40 ns holdoff time.
Persistence off, 20% grid intensity.
Acquire mode normal, [Run/Stop] to Run, cursors and measurements off.
All custom labels that you have created in the Label Library are preserved (not
erased), but all channel labels will be set to their original names.
1
Getting Started
27