Bosch SMB365 Application Note page 18

4. After starting the software, the cockpit window of the BlueBox software appears. The
software tries to locate automatically the corresponding COM port of the demo board. If
the demo board is located, a status message at the bottom left hand corner of the
software window will indicate to which COM port the module is connected. If the status
window indicates "Module not found" the board has to be located manual. Only in this
case click on "File"
Select „File"
5. Press the „Start" button to start data acquisition of acceleration and pressure sensor
6. Accelerate, roll, tilt or lift the BlueBox board
7. Watch the graphs in the different displays on the cockpit screen
o Note: For exact altimeter response it is strongly recommended to correct the
ambient air pressure data before further using the board (see chapter 3.3)
Rev. 1.0
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
copying and passing onto third parties.
.
7211RB11
Application Note
BlueBox Demo-Board for the digital sensors
SMB365 (acceleration) and SMD500 (pressure)
"Detect Module on COM Port" in the status bar.
"Detect Module on COM Port" for manual COM port location
Status window
Start data acquisition
Page 18
Bosch Sensortec
AN18002