Table of Contents
Advertisement
3. Altitude Display (SMD500)
•
The display shows the primary output signal of the SMD500 converted to altitude
•
8.5 m differential height corresponds to an differential pressure of about 1 hPa
pressure at sea level
•
The abscissa (x-coordinate) corresponds to time in seconds
•
The ordinate (y-coordinate) corresponds to altitude in meter or feet
•
The ordinate features custom min/max scaling
4. Yaw Display (SMG300)
•
Disabled on BlueBord V1.0
5. COM Port Status Window
•
Indicates connection status of the BlueBoard demo board
6. Temperature Display (SMD500)
•
Display shows temperature as a secondary output signal of the SMD500 in °C,
°F or K (details see chapter 4.2 [18] )
•
The abscissa (x-coordinate) corresponds to time in seconds
•
The ordinate (y-coordinate) corresponds to the temperature in °C, °F or K
•
The ordinate features custom min/max scaling
7. Pressure Display (SMD500)
•
Display shows the primary output signal of the SMD500 in hPa, PSI or mm Hg
•
1hPa is equal to a pressure of 1mbar
•
The abscissa (x-coordinate) corresponds to time in seconds
•
The ordinate (y-coordinate) corresponds to absolute pressure in hPa, PSI or mm Hg
•
The ordinate features custom min/max scaling
8. Start button
•
To start data acquisition of acceleration- and pressure sensor output signals
9. Stop button
•
To end data acquisition of acceleration- and pressure sensor output signals
Rev. 1.0
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
copying and passing onto third parties.
.
7211RB11
Application Note
BlueBox Demo-Board for the digital sensors
SMB365 (acceleration) and SMD500 (pressure)
Page 26
Bosch Sensortec
AN18002
Advertisement
Table of Contents
