Table of Contents
Advertisement
•
If the Direct Data Export is activated correctly, the status message "Data export on"
appears at the bottom of the Sesor Desktop software window.
•
If the data acquisition is started by a click on "Start", only the tab-corresponding data will
be exported. Regarding the figure above, only acceleration data will be exported.
Rev. 1.0
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
copying and passing onto third parties.
.
7211RB11
Application Note
BlueBox Demo-Board for the digital sensors
SMB365 (acceleration) and SMD500 (pressure)
Status message
Page 43
Bosch Sensortec
AN18002
Advertisement
Table of Contents
