Table of Contents
Advertisement
3.2
Bluetooth wireless
1. Make sure that the used PC or laptop supports Bluetooth capability.
2. Make sure that system specific Bluetooth hard- and software as well as drivers are
installed and activated.
3. Before using wireless data transmission via Bluetooth start up the BlueBox once
according to chapter 3.1 and let the BlueBox connected at least 5 hours to fully charge
the battery pack.
Bluetooth Device ID
Bluetooth unit
4. Double Click on the Bluetooth symbol
software to set up the correct Bluetooth environment for the BlueBoard.
o Bluetooth software must support SPP Protocoll (Serial Port Profile) and virtual
serial COM port respectively
o Configure according to "Pair Devices" or "Pairing"
5. Turn on the BlueBox demo board (USB cable disconnected) for wireless use
6. Search for the corresponding Bluetooth Device ID in Bluetooth environment
in this example "7763" according to the illustration above
o When asked for Bluetooth Pin or Key enter "0000"
8. Execute the SensorDesktop software on the PC from Start\Programs\ SensorDesktop
Rev. 1.0
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
copying and passing onto third parties.
.
7211RB11
Application Note
BlueBox Demo-Board for the digital sensors
SMB365 (acceleration) and SMD500 (pressure)
in the system tray or start your Bluetooth
Page 19
Bosch Sensortec
AN18002
Main Switch
Advertisement
Table of Contents
