Programming- Operator Access Programming - Fetco CBS-2131 User Manual

Programming- operator access programming

-The FETCO CBS-2130 brewers have four brew batch menus per side.
They are preprogrammed with basic settings that will operate the equipment as purchased.
There are two batches each marked "Regular" and two marked "Decaf"
-Most operators prefer a full batch and half batch setting for regular and decaf or specialty coffees. These will need
to be programmed by the operator
-Settings are adjustable and the names can be changed. -Batch 1 & 4 cannot be disabled.
Menu screen displayed
(FETCO "HOME" screen)
Programming-category screens: Menu Tree
To enter:
Turn unit "OFF", After 10 second delay, turn unit "ON", (Home Screen will appear),
Immediately place finger on screen and "HOLD" PROGRAM
Use right/left and down arrows to travel through programming. "EXIT" saves settings
Programming Category
PROGRAM
Items for Programming
Batch 1 LEFT*
Batch 2 Left**
Batch 3 Left **
Batch 4 Left **
Batch 1 RIGHT*
Batch 2 Right **
Batch 3 Right **
Batch 4 Right **
Batch Copy
Accessing
Programming
Turn unit "OFF"
After 10 second delay:
Pre-check will display:
voltage calibration for pumps is
running...Please wait...Calibration
is successfully done".
Turn unit "ON"
"HOME" Screen on left will
appear
Immediately place finger on
screen and "HOLD"
Screen on right will appear
Programming category screens
Programming Category Programming Category
GENERAL
Items for Programming
Tank Temp Display Inputs
Brew At Temp Calib Touch Scr
Unit of Meas.
Volume
ECO Mode
Logo Timeout
Brew B.Sensor
Menu screen displayed
<
PROGRAM
"DC <
Batch 1 Left
EXIT
<<
Programming Category
INPUTS
Items for Programming
Left Pump
L.Bypass Pump*
Right Pump
R.Bypass Pump*
Fill Valve
Heater
Screen
*
1 gallon airpot version
12
Accessing
Programming menu
screens
> Top line is programming
category
>
Second line displays
items for programming
Right and left hand arrows
will scroll to the screens that
display "Program, General,
>>
Inputs, Outputs and Other".
Down arrow enters the
individual programming items
shown below
Screen (first below) will appear.
Programming Category
OUTPUTS
Items for
Items for Programming
Programming
Error Codes
Display Errors
Reset Errors
Copy Program
From SD to B
From B to SD
Upload Logo
Res to Factory
Bypass option is only on
Firmware
OTHER