Fetco Extractor CBS-2061e User Manual page 7

Final Setup
1. Turn on the incoming water supply line and inspect both inside
and outside of the brewer for leaks in all fittings and tubes
2. Turn on the incoming power.
3. Press the brewer's main power switch, which is hidden behind
the front leg of the brewer. The control panel on/off switch will
begin flashing. Press this switch while it is flashing.
4. Within 6 seconds, the hot water tank will begin filling until the
water is sensed by the probe at the top of the tank. The display
will read "FIL". The heaters will be disabled by the control board
until the tank is full.
5. While the water is heating, the display will read "LO" and the
actual water temperature will be displayed. After the water has
reached the set temperature, the display will be blank. There is
no "ready" light.
6. Review the Operating Instructions. Brew one full batch (water
only) on each side to confirm proper fill levels. The brewer is
factory set with water only (no coffee) to dispense the correct
amount of water. If the actual volume is slightly different from the
programmed volume, fine tuning the brewer may be necessary.
See #60 – 63 in the Advanced Settings & Diagnostics section.
7. Re-attach the covers after one final inspection for leaks. Look
closely in the top of the brewer at the dispense fittings during this
inspection.
Operator Training
Review the operating procedures with whoever will be using the
brewer. Pay particular attention to the following areas:
1. Always pre-heat the dispensers before the first use of each day
by filling them half way with hot water, and letting them stand for
at least 15 minutes.
2. Don't remove the brew basket until it has stopped dripping.
3. Make sure the dispenser is empty before brewing into it.
4. Show how to attach covers, close, and or secure the thermal
dispensers for transporting.
5. Show the location and operation of the water shut off valve as
well as the circuit breaker for the brewer.
6. Steam from the tank will form condensation in the vent tubes.
This condensation will drip into and then out of the brew baskets.
1/4 cup discharging overnight is possible. Place an appropriate
container under each brew basket when not in use.
7. We recommend leaving the power to the brewer on overnight.
The water tank is well insulated and will use very little electricity
to keep the tank hot. Leaving the brewer in the on position will
also avoid delays at the beginning of shifts for the brewer to
reach operating temperature.
7
CBS-2062e