Remote Control; Troubleshooting - Silvercrest KH 2391 Operation Manual

Disconnection
• Remove the USB plug of the USB audio storage
medium completely from the USB port
Or
• Press the SD / MMC in the SD and MMC port
in order to unlock it.
• Remove the SD / MMC from the SD and MMC
dn
port .

Remote Control

L
Tip!
Familiarise yourself with use of the similar buttons
on the remote control (see Fig. F). Please see the
layout of the control panel
Ensure that the front edge of the remote control is
pointing in the direction of the sensor
1
mote control .
• Please note that the AF function only works with
ther button
AF
• Please also note the modified procedure for:
Adjusting the Volume
• Increase the volume by pressing the
button gt .
VOL+
• Reduce the volume by pressing the
VOL-
hm
button .
Inserting the Battery
• Press the unlock button
battery holder io
in
ment (see Fig. G).
• Insert a lithium battery of type CR202, 3 V DC
into the battery holder
the side marked with a "+" is facing upwards.
Then push the battery holder
compartment in

Troubleshooting

L
E Fault e Cause
E The device cannot be switched on and / or
[ERROR] appears in the display window
The connections of the 12 V DC power supply
KH2391_Content_UK.indd 21
do .
1
for the functions.
3 of the re-
8 on the control panel
ip and remove the
from the battery compart-
io in such a way that
io into the battery
until it distinctly locks into place.
E
Correction
Operation / Remote Control / Troubleshooting
are faulty.
E
Check that the wiring of the device is correct
(see the section on „Connecting to the Vehicle's
12 V DC Power Supply"). Then press the RESET
dn dr
button with the tip of the ballpoint pen.
Or
The 10 A f l flat blade fuse in the flat blade
eu
fuse socket
E
Replace the broken flat blade fuse with a new
10 A flat blade fuse. Then press the RESET
dr
button with the tip of the ballpoint pen.
Or
A 1 A fuse of the fuse holder of the 12 V DC
power supply is broken.
E
Replace the broken fuse with a new 1 A fuse.
Then press the RESET button
the ballpoint pen. If the fuse is broken again,
check that the wiring is correct.
Or
The device is broken.
E
1 . Please contact the service centre for your
country (see guarantee card).
E The device cannot be operated.
The control panel
E
Ensure that the control panel
connected (see the section on attaching the
control panel).
Or
The battery of the remote control is flat.
E
Replace the used battery with a new lithium
battery of type CR202, 3 V DC.
Or
The sensors 3
remote control may be dirty.
E
Clean the sensor
the remote control if necessary.
Or
The device is broken.
E
Please contact the service centre for your
country (see guarantee card).
E The stored stations do not remain stored if
the control panel is removed or the engine
turned off.
9 . The connections for 12 V constant current
12 volt ignition current
is broken.
dr
with the tip of
1
is wrongly connected.
1 is correctly
of the control panel 1 and / or
3 1
of the control panel
fn
fp
have been mixed up
GB/IE
05.09.2006 14:49:18 Uhr
or
and
21