Set Mode; I Set Mode Programming - Icom IC-M503 Insrtuction Manual

6

SET MODE

I Set mode programming

Set mode is used to change the conditions of the trans-
ceiver's functions: scan mode (normal or priority), scan re-
sume timer, dualwatch/tri-watch selection, beep tone function
(transceiver or HM-134), internal speaker (transceiver or HM-
134), LCD contrast (transceiver or HM-134), scrambler code,
scrambler type and ATIS check.
• Available functions may differ depending on dealer set-
ting.
• The optional HM-134 has it's own settings for the beep
tone, internal speaker and LCD contrast.
• SET MODE CONSTRUCTION
ATIS check
Scrambler type
14
q Turn power OFF.
w While pushing and holding [16], turn power ON to enter set
mode.
e After the display appears, release [16].
r Push [16] to select the desired item, if necessary.
t Rotate the channel selector to select the desired condition
of the item.
y Turn power OFF, then ON again to exit set mode.
Scan mode Scan resume timer
Push
16
Scrambler code LCD contrast
Dual/tri watch
Beep tone
Internal speaker