Kodak i1800 Series Image Processing Manual page 72

Device - OCP tab
3-44
The OCP tab is used to setup options on the scanner's Operator
Control Panel (i.e., touchscreen).
Function Keys — available functions for each key are:
• (none)
• Stop Scanning: scanning will stop and control will return to the
scanning application (i.e., ends the job). Restart the scan session
from the scanning application.
• End Batch: start a new batch by resetting the batch count (i.e. How
Many to Count) and continue to scan.
• Omit Multifeed: turn off multifeed detection only on the next
document that is fed.
• Omit Print: turn off printing only on the next document that is fed.
• Omit Patch: turn off patch recognition only on the next document that
is fed.
• Lower Elevator: moves the elevator to the lowest position.
NOTE: The End Batch and Omit Patch options are only available
when the scanner is in Image Address mode.
A-61580 November 2007