Kodak i1800 Series Image Processing Manual page 28

Batching
2-24
Batching information only applies when the scanner is configured with
Image Address enabled via the operator control panel touchscreen.
Batching provides a way for the scanner to perform a specific function
after scanning a designated number of documents at a particular IA
level.
Batching can be enabled or disabled through the host software. The
host software has control of which level to count and the number of
documents to designate a batch.
The Start of Batch function is controlled by the host and determines
what happens when a new batch is started. This can be setup to go to
Level 1, 2 or 3, which then causes the IA to be recalculated. The Start
of Batch function can also be set to no function.
The End of Batch function is controlled by the host and determines
what happens when the batch count has been reached. The options
are to stop the feeder, end of job, or continue and begin a new batch.
No functionality can also be assigned.
The host application determines if batching is enabled by defining the
number of documents per batch and the image address level to count.
A-61580 November 2007