Kodak i1800 Series Image Processing Manual page 67

A-61580 November 2007
NOTES:
• When you make a Format selection, the Field width and Next Level
settings will automatically be set to the defaults for that format.
• If you made a change to the Field width or Next Level settings, the
Format will be appended with the text <changed>, and the name will
be displayed in italics (e.g., *Level 3 <changed>).
• Reset: allows you to undo any changes that have been made to
the format. This is only available when you have modified the format
(e.g., are in italics and appended with <changed>).
• Field width — allows you to configure the width of each field from
1 - 9. However, the sum total of all the field widths cannot exceed 27,
therefore, the field width may be limited to a value less than 9.
• Next Level: the level to assign to the next document.
- After Level 3: allows you to select what level to assign to the
document that follows a level 3 document.
- After Level 2: allows you to select what level to assign to the
document that follows a level 2 document.
- After Level 1: allows you to select what level to assign to the
document that follows a level 1 document.
The options for all three of the above are: Level 1, Level 2, and
Level 3. However, the available options are based on the image
address format. For example, if the Format does not have Level 3
as one its fields, then Level 3 will not available.
NOTE: While scanning, a document can also be assigned a level by
inserting a patch sheet (when turned on via the Patch tab) or
selecting a level field on the scanner's touchscreen. For more
information refer to the User's Guide which is included with
your scanner.
Leading zeros  allows you to configure the format of the level
address fields when the width of the value is less than the field width
(the examples indicate a field width of 3 and the image address at
A.3.2.1).
• Display (e.g., A.003.002.001)
• Do Not Display (e.g., A.3.2.1)
• Display as Spaces (e.g., A. 3. 2. 1)
3-39