Page 1
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 SCEIS Imaging: Kodak i1220 Scanner Installation and Configuration Guide If your scanner is already installed, go to the CONFIGURATION section on page 3. Configuration will set the scanner to ignore blank pages.
Page 2
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 Click ‘Yes’ and ‘Never Ask Me Again’ then ‘OK’ Click ‘OK’ to close the Citrix Connection Center Page | 2...
Page 3
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 CONFIGURATION On your Windows main screen… Go to Start >> Programs >> Kodak >> Document Imaging >> Scan Validation Tool Select ‘TWAIN’ Click ‘OK’ Wait while the connection to the scanner is made.
Page 4
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 Select the ‘Setup’ icon Select ‘Default’ or ‘SCEIS Default’ if it is listed Select ‘Two Sided’ Click ‘Settings’ Page | 4...
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 Select each tab and make the settings identical to the screenshots GENERAL TAB Page | 5...
Page 6
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 In the ‘Side’ field on the General tab the word ‘Both’ should be grayed out. If it says ‘Front’ or ‘Back’ instead of ‘Both’ click the ‘Advanced Image Setup’ icon Select ‘Two Sided’...
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 When you are done with all of the Image tabs (General / Size / Adjustments / Enhancements)… Click the ‘Device’ button at the bottom of the screen. DEVICE SCREENS Select each tab and make the settings identical to the screenshots...
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 MULTIFEED TAB Important Page | 11...
Page 12
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 When you are done with the Device tabs (General / Multifeed) … Click the ‘Home’ button at the bottom of the screen. Click ‘Save As’ Enter Shortcut name: ‘SCEIS Default’ Click ‘Save’...
Page 13
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 Important If ‘SCEIS Default’ is not at the top of the list, highlight ‘SCEIS Default’ and click ‘Move Up’ to put it at the top. Click ‘OK’ at the bottom of the screen.
Page 14
Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012 LOCK THE SCANNER CONFIGURATION TO ‘SCEIS DEFAULT’ The following steps lock the ‘SCEIS Default’ settings when scanning in OnBase and also allow you to use the scanner for other applications on your workstation. You should perform the steps below even if you do not use other scanning applications.