Motorola 68390 - Vanguard 320 Router User Manual page 26

A p p l i c a t i o n V i e w s
Backup Port
The port or channel that acts as the backup when
there is a port failure on the port specified by the
parameter Monitored port, or primary destination
port (activated by call). The format must be the
following: X25-n or BRI-nCm, where n is the port
number and m is the channel number.
Dialed No.
The telephone numbers that will be dialed when
the backup port is activated. To enter your own
telephone number, use any combination of the
following characters:
0-9 Decimal
: Wait Tone
< Pause
= Separator 3
> Separator 4
P or p Dialing to be continued in PULSE
mode.
T or t Dialing to be continued in DTMF mode.
& Flash
To have the modem dial one of its pre-
programmed telephone numbers, enter:
#n where 'n' identifies the pre-programmed
telephone number stored in the modem.
D e v i c e M a n a g e m e n t
Act Mode
This specifies how the switched service/backup
port will be activated.
activation modes and descriptions:
Table 6: Activation Mode
Mode
fail
call
either
newvalFail
Deact Mode
This specifies how the switched service/backup
port is deactivated after the original link is up.
Table 7 displays the deactivation modes and
descriptions:
Page 26
S u p p o r t e d A p p l i c a t i o n s
Table 6 displays the
Description
Activate the backup port upon
link failure.
Activate the backup port upon a
call request.
Activate the backup port upon
link failure or a call request.
Same functionality as 'fail,' new
enumeration added for RFC1155
compatibility.
M o t o r o l a V a n g u a r d