Furuno FR-2125V Installation Manual page 41

HEAD UP TB SCALE: Bearing scale may be shown in degrees or compass
points in the head-up mode.
CTR ECHO STRETCH: Turn on to enlarge echoes in the range up to the first
range ring.
VIDEO CONTRAST: For factory use. Do not change setting.
MAXIMUM RANGE: For factory use. Do not change setting.
ECHO FULL COLOR: Echoes may be displayed in one color or multi-color. Se-
lect ON for multi-color display.
INDEX LINES: Selects the number of index lines to display; 2, 3, or 6.
INITIAL SETTING4 menu
Keying sequence: [RADAR MENU] [0] [0] [0] [2] [0] [0] [0]
MODEL: Selects radar model.
TYPE: Selects specification of radar.
CTR STC CURVE: Selects level of STC affect; Low, Medium or High.
RJ-7, RJ-8: Selects which Interswitch unit to use.
SHIP'S TYPE: Select class of vessel; deep sea, fishing, long line fishing.
CABLE LENGTH: Set for "500."
FACTORY DEFAULT: Restores all menus' default settings.
OWN SHIP INFORMATION menu
Keying sequence: [RADAR MENU] [0] [0] [0] [2] [6]
SHIP'S LENGTH: Enter ship's length.
SHIP'S WIDTH: Enter ship's width.
RADAR POSN: Enter distance from both bow and port to the radar antenna
location.
NAV ANT POSN: Enter distance from both bow and port to the navigation an-
tenna location.
TURN RATE: Enter ship's turn rate.
SPEED RATE: Enter ship's speed rate.
I/O Data Sentences
Input: GGA, RMA, RMB, RMC, GLL, ZDA, VBW, VHW, VTG, MWV, VWT,
VWR, VDR, DPT, DBT, DBS, MTW, BWR, BWC, WPL, RTE
Output: RAOSD, RARSD, RATTM
Note: Unit of Range Measurement
The default unit of range measurement is NM (nautical miles). To switch to SM, press [4],
[5], [6] while pressing the [HL OFF] key. Then, reset the power.
3-7