Furuno FR-2125V Installation Manual page 14

b) While pushing the stopper, set the catch on the display unit in the hole at the
front edge of the stay.
Figure 1-9 Setting catch to hole in stay
c) Release hand from stopper.
6. Fasten the display unit to the mounting location at front fixing holes (2 points)
with M10 bolts, nuts and flat washers, using the pipe box spanner (supplied).
You cannot fasten the display unit at the rear fixing holes while the monitor is
raised.
7. Retract the stay and lower the monitor. Pull the monitor toward you by the
handle at the front of the display unit until you hear a click.
8. The rear left fixing hole is hidden under the PTU board cover. Remove the
cover as follows:
(1) Unfasten three M4X8 screws to remove the lead-in cover (V) which hides
the PTU section. Slide the cover to remove it.
Pan-head Screw
M4X8, 4 pcs.
Figure 1-11 How to remove the lead-in cover
Stopper
Catch
Release stopper;
fix stay.
Figure 1-10 Stay fixed
Lead-in Cover (V)
1-7
Stay
REAR SIDE