Furuno FR-2125V Installation Manual page 10

Antenna radiator
Guide pin
(XN20AF,
Figure 1-3 Fastening the radiator to the radiator bracket
Fastening the antenna unit to the mounting platform
The antenna unit may be assembled before hoisting it to the mounting platform.
However, do not hoist the antenna unit by the radiator. Always hoist the unit by its
housing. When using a crane or hoist, hoist the unit by the hoist rings which should
be fastened to the bolt fixing covers of the antenna housing.
1. Construct a suitable mounting platform referring to the outline drawing at the
back of the manual.
2. Drill four mounting holes of 15 mm diameter and one cable entry hole of about
50 mm diameter in the mounting platform.
3. Lay the rubber mat (supplied) on the mounting platform.
XN24AF
only)
CAUTION
DO NOT hoist the antenna unit by the
radiator; lift it by the hoist rings. (Be sure to
remove rings after hoisting the antenna unit.)
Hoist
ring
1-3
Waveguide
Radiator bracket
Hex bolt (M8X40), 8 pcs.
(XN20AF, XN24AF only)
Hex bolt (M8X35), 8 pcs.
Flat washer
Spring washer
(XN12AF only)
O-ring
NO!