Leading cables into the display unit
The cable clamp may be positioned within the display unit (default arrangement),
outside the display unit or at the bottom of the display unit (when using console
mount, for example). When the cable clamp is located outside or beneath the dis-
play unit, use the bottom clamp front plate and bottom clamp rear plate (supplied
with installation materials).
Also, use the shielding foam (supplied) to guard against noise.
Cable fed from rear of display unit (Default method)
Nav equipment
(Gyrocompass)
Keyboard
Log
PWR
Cable position in clamp
(Display unit, rear view)
(D) Rear clamp plate
(C) Signal cable
(Aluminum)
(B) Power clamp
(Aluminum)
(A) Rear clamp base
(Display unit, right-hand side view)
•
Place shielding foam between cables, and then attach foam to aluminum clamps.
•
Fill unused clamp holes with shielding foam.
Slave display
Navigation
ANT
External CRT
Make sure foam contacts rear chassis.
Rear cable entrance
Cable
Shielding foam
Figure 2-10 Default cable clamp position
Hex bolt
M5X12 SUS,
2 pcs
Hex bolt
M5X35 SUS,
2 pcs
Hex bolt
M5X35 SUS,
2 pcs
(Construction of
cable clamp)
(Display unit, rear view)
2-8
Pan-head screw
M4X8
(D) Rear clamp
plate
(C) Signal clamp
(Aluminum)
(B) Power clamp
(Aluminum)
(A) Rear clamp
base