Furuno FR-2125V Installation Manual page 20

Control head modification procedure
1. Unfasten eight screws (M4X8) on the underside of the control head. Unplug
connectors P314, P312 and P317 from the control head. Separate the KB bot-
tom plate from the control head.
2. Unfasten the screw (M4) fixing the ground terminal and two screws (M4X8)
fixing the clamp. Remove the connection cable assy.
3. Unfasten two screws (M6X12) from the inside of the bottom plate of the control
head to dismount the handle.
4. Replace the cable assy. with cable assy. UL2464SB2-0P/1P (10 m, supplied)
as below and reassemble the control head.
P312 FX Connector
Upset Screw
M6X12 (2 pcs.)
KB Clamp
Handle
Replace with
cable assy. in
kit.
Earth Wire
Spacer
Pan-head Screw M4X8 (2 pcs.)
Be careful not to pinch cable between
KB clamp and spacer.
Figure 1-16 Control head
1-13
KB Fixing Plate
Lay cable in slot.
P314 XH3P
Screw
M4X8 (8 pcs.)