Furuno FR-2125V Installation Manual page 18

11. Unfasten four upset screws (6) at the bottom of the right and left KB arms to
dismount the control head.
12.Unfasten three screws (M4X10) and two screws (M4X8) to remove the right
lower cover (7) and the left lower cover (8).
Pan-head Screw (M4X10, 3 pcs., upper)
Binding Screw (M4X8, 2 pcs., lower)
Left Lower Cover (8)
Monitor
J582
J581
Remove clamp from rear side
Figure 1-14 Clamp position
Control Head
Upset Screw (6)
(M5X25, 4 pcs.,
including those on
opposite side)
Figure 1-15 Display unit, front view
1-11
Control Head Cable
Clamp
Remove clamp
from left side
Right KB Arm
Right Lower Cover (7)
Pan-head Screw (M4X10, 3 pcs., upper)
Binding Screw (M4X8, 2 pcs., lower)