Erasing An Ebl, Ebl Indication; Erasing Ebl/Vrm Data Boxes; Hiding Ebl/Vrm Data Boxes; Moving Ebl/Vrm Data Boxes - Furuno COLOR VIDEO PLOTTER 1833C Operator's Manual

4. You may hide the EBL/VRM soft keys by pressing the [EBL/VRM] key.
Note: The bearing to a target may be shown relative to own ship's heading
(Relative) or True bearing (requires heading data). This may be done with
"EBL REFERENCE," which is in the RADAR DISPLAY SETUP menu.
2.11.3

Erasing an EBL, EBL indication

Press appropriate EBL soft key, then press the [CLEAR] key. The EBL is erased
and its indication becomes blank.
2.11.4

Erasing EBL/VRM data boxes

Press the EBL or VRM soft key associated with the EBL/VRM data box you wish
to erase. Press the [CLEAR] key once or twice to erase the data box.
2.11.5

Hiding EBL/VRM data boxes

Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the
EBL/VRM data boxes.
2.11.6

Moving EBL/VRM data boxes

When an EBL/VRM data box is obscuring a target you want to see, you can
move it to another location as shown below. This cannot be done when the
EBL/VRM soft keys are shown.
1. Press the [EBL/VRM] key to turn off the EBL/VRM soft keys.
2. Using the trackball, place the cursor inside the data box you wish to move.
As the cursor enters the box it changes to a "hand." Push the [ENTER] knob,
and the hand changes to a fist, meaning the box is correctly selected.
3. Use the trackball to move the data box to the location desired, then push the
[ENTER] knob.
3nm
12/
LP
H-UP
EBL1
(Dotted line)
EBL2
(Dashed line)
EBL2 bearing
EBL1
EBL1 bearing 330.1 R
VRM1
-.---nm
How to measure bearing with the EBL
319. 9
EBL2
234.1˚R
VRM2
-.---nm
Active marker is highlighted.
2. RADAR OPERATION
EBL
M
VRM
EBL1
ON
VRM1
ON
OFFSET
EBL2
ON
VRM2
ON
359.9 ˚R
+
11.70
nm
2-15