Furuno COLOR VIDEO PLOTTER 1833C Operator's Manual page 133

Restarting navigation
When you steer to avoid an obstacle or the vessel drifts, you may go off your
intended course, as in Line 1 in the figure below. Also, if you don't need to return
to the original course, you can go directly to the next waypoint, as in Line 2 in
the figure below. In these cases, use the restart navigation function to restart
navigation.
1. Press the [MENU] key to open the menu.
2. Press the WAYPOINTS/ROUTES soft key.
3. Press the LOG soft key.
Replaces triangle
when selecting a
route leg.
4. Use the trackball to select a waypoint or a route leg. When a route leg is
selected the single arrow cursor is replaced by double arrows.
5. Press the RESTART soft key or FOLLOW LEG soft key in case of route leg.
Note: Navigation may be restarted from the plotter display, with the
RESTART key, when a single quick point (QP<01>) is selected for
navigation.
6. Press the [MENU] key to close the menu.
Obstacle
Original course
Example of when to restart navigation
TO Waypoint (WPT name in reverse video)
Passed waypoint (gray characters)
Estimated Time of Arrival at destination
ETA 23:59 30. APR
48 18.290'N
01
123 14.286'W
007WPT
02
02 48 17.341'N
123 10.232'W
005WPT
03 48 20.261'N
123 11.658'W
003WPT
04 48 19.862'N
123 04.190'W
006WPT
Log display
3. PLOTTER OPERATION
Line 2
Line 1
LOG
LEG
RE-
START
90.0
2.86nm
STOP
322.6
3.08nm
RVRSE
75.2
4.99nm
SPEED
152.5
19.87nm
COORD
TYPE
Replaced by
"FOLLOW LEG"
when selecting
a route leg.
3-49